WEIHONG Lambda 5S Series User Manual

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 12 - Specialized, Concentrated, Focused
WARNING
Terminals Y00/C00 and Y01/C01 (marked with in the wiring diagrams below) on Lambda 4S/5S controller
should only be connected with load of voltage lower than or equal to 24V, otherwise, they will be damaged and
cannot work due to burn-out of the piezoresistor, since a protective circuit is added to them for brake function (for
serial connection with 24V motor brake coil).
 Four Axes Engraving and Milling
Cycle Start
Cycle Stop
Tool Sensor Signal
Oil Level Detection
Spindle Alarm
ESTOP
FeedRate Band-switch A
FeedRate Band-switch B
FeedRate Band-switch E
Z-axis Brake
X Axis REF. Point
+X Limit
-X Limit
Y Axis REF. Point
+Y Limit
-Y Limit
+Z Limit
-Z Limit
Z Axis REF. Point
+A (4th) Limit
-A (4th) Limit
A (4th) Axis REF. Point
+24V Power
Active High/Low
Z-axis Brake
Spindle ON
Coolant
Lube Oil
Illumination
Green
Red
Yellow
Common
Common
Common
Common
Common
Analog Output
To connect
NC65A/65B
PM85A/95A
To connect
X-axis driver
To connect
Y-axis driver
To connect
Z-axis driver
To connect A
(4th) axis driver
To connect
MPG
FeedRate Band-switch F
Spindle Override Band-switch A
Spindle Override Band-switch B
Spindle Override Band-switch E
Spindle Override Band-switch F
General Input
Fig. 2-3 Connection according to four axes engraving software

WEIHONG Lambda 5S Series Specifications

General

Brand	WEIHONG
Model	Lambda 5S Series
Category	Controller
Language	English