上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 44 - Specialized, Concentrated, Focused
3 Installation
3.1 PM85A/95A Communication Card
3.1.1 Installation Steps
1) Insert the software CD into the CD driver of computer, double click in the NcStudio software
CD, and then install the software according to the prompts of the software installation wizard;
2) Power off the computer, open the computer chassis, insert the communication card into a PCI slot
(for PM85A) or PCI-E slot (for PM95A), fasten the screw of rail block, and cover the computer
chassis;
3) Power on the computer, the computer to find the new hardware-device automatically. And then
install the driver manually according to the driver installation wizard;
4) Double click the shortcut icon of NcStudio on the desktop; if it runs normally, installation is
completed (if the software fails, please check whether the communication card is well inserted and
whether gold fingers are clean).
3.1.2 Driver Update
If the system does not prompt finding a new device, you can update the driver manually by following
the steps below:
1) Right click ―My Computer‖, select ―Properties‖, and click ―Device Manager‖ under ―Hardware‖ tab in
the ―System Properties‖ window. And then find ―CNC Adapters‖ in the pop-up ―Device Manager‖
window, right click the option under ―CNC Adapters‖, and select ―Update Driver…‖ to start updating
the hardware driver. A new window appears, as shown in Fig. 3-1.
To Next Page
Loading...
Need help?
General
