上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
9 / 97
– + : It is used to make the fine adjustment.
• Button combination (Exclusive to General NK105 with double Z axes)
– + : It is used to clear the workpiece coordinate of Y-
axis.
– + : It is used to activate axes.
– + : It is used to switch between Alternative and
Linkage mode. See Select the Aixs Mode for details.
– + : It is used to set the tool length of Z1-axis.
– + : It is used to set the tool length of Z2-axis.
To Next Page
Loading...
