WM 68331 04/2021
LIFE-BASE EN 25
4 Assembly
4 Assembly
This section describes the assembly of all versions of the portable
unit and accessories. If there are significant differences in
the assembly of the versions, these are explained. Otherwise,
assembly is the same for all versions.
4.1 Attaching the protective bag to
the portable unit
4.1.1 Attaching the protective bag for
LIFE-BASE light
1. Place the protective bag on a flat, firm surface.
2. Position the portable unit from behind on the base of
the protective bag.
3. Pull the protective bag over the portable unit.
4. Close the hook and loop fastener on the back of
the protective bag.
To Next Page
Loading...
