ZIF connectors use a sliding outer piece that latches and unlatches to secure and release the
flex cable. ZIF cables cannot be successfully connected or disconnected without properly
unlatching and latching the sliding outer piece.
Caution Do not use excessive force when releasing pressure on
the connector. Excessive force may result in breaking the sliding
outer piece.
To remove a ZIF connector
Caution Remove a flex cable only after the ZIF latch is open.
1. Using a suitable tool (for example, a paper clip, small flat-head screwdriver, or needle-
nose pliers), slide the latching piece of the connector away from the connector body.
2. Remove the cable.
To connect a ZIF connector
1. Slide the latching piece of the connector away from the connector body.
2. Insert the flex cable into the connector. This may require using a suitable tool to keep the
latching piece elevated.
3. Slide the latching piece toward the connector body until it locks into place.
Connectors
Main board connectors
Service manual Appendices 119
To Next Page
Loading...
