Wilo Control SC-Booster - Page 102

English
Installation and operating instructions Wilo-Control SC-Booster (SC, SC-FC, SCe) 31
SCe
SC FC
Speed in the event of a sensor fault.
Can only be changed when the drives are switched
off.
f
min
… 60 … f
max
SCe NWB Type of the (relative) supply pressure. Can only be
changed when the drives are switched off.
If the intention is to use absolute pressure sensors,
please contact Wilo customer service.
0–6
0–10
-1 – 9
-1 – 1
off (only p-c)
Except
SCe NWB
The menu for the external setpoint
Except
SCe NWB
Activate external setpoint OFF
ON
Limit values
The maximum pressure which is to be permitted
on the outlet side. This value is set relative to the
current setpoint.
101.0 … 150.0 …
300.0
The absolute maximum pressure on the outlet side.
This value is automatically calculated based on the
relative maximum pressure and the current setpoint.
The minimum pressure which is to be permitted
on the outlet side. This value is set relative to
the current setpoint. The value 0 deactivates this
control.
0.0 … 99.0
Valid until Display
Description
Parameter range
Factory setting