25
2. For the Installer
2.9 Installation sequence
On request the FireWIN can be supplied with various accessories, e.g. the UAM/UAML fitting set or feed unit.
The installation sequence is as follows:
a) Fit the UAM/UAML fittings / hydraulic assemblies (see separate installation instructions) or, without fittings,
fit the flow and return pipes – see 2.10.
b) Install the feed unit – see separate installation instructions.
c) Install the FireWIN cladding – see 2.12.
d) Mounting plate for non-flammable steel tubes within the area of the exhaust pipe – see 2.13.
e) Installing cover plates – see 2.14.
f) Install the exhaust pipe – see 2.15.
2.10 Installation of hydraulic equipment / fittings
The hydraulic fittings must be fitted in the FireWIN prior to installation.
2.10.1 Installation of fittings for FireWIN UAM / UAML
See separate assembly instructions: „Fitting the hydraulic assemblies UAM / UAML in the FireWIN or VarioWIN
pellet boiler“.
2.10.2 Installation of flow and return pipes for FireWIN without fittings
comprises the following parts:
Fig. 20 Flow and return pipes for FireWIN
1 ...........Return corrugated tube
2 ...........Klingerit seal for return line
3 ...........Screw for attaching return pipe
4 ...........Return pipe
5 ...........Cable tie
6 ...........Flow pipe
7 ...........Screw connections with seal for flow pipe
1
2
3
4
5 6 7
To Next Page
Loading...
