Windhager FireWIN - Service Level

37
4. For the Service Technician
Actuator test
Menu
Number of burner
starts
Fuel quantity
auger conveyor
Operating time of
suction turbine
Maximum value of
set temperature
Hysteresis
burner ON
Type of pellet feed
system
Ash removal
profile
Flue gas thermostat or
Air intake/ exhaust flap
Parameters Start-up
Auger conveyor Feed
Induced draught fan
Auger conveyor
Ash removal Suction turbine
Ignition element
Ash removal
Heating surfaces
cleaning
Probe switching
Air intake/exh. flap
Pumping time
ignition phase
Set temperature ext.
heating requirement
Cleaning interval
correction
Limits for
blower speed
Boiler pump
Settings
Install display
module
Language selection
Time format
Temperature format
Date format
Minimum operating
time with buffer
Operator level
Settings on the operator level
see BioWIN Operating Manual.
Service level
Reserved for trained service
personnel only.
Information level
(see operating instructions for
FireWIN)
MES Module
1
(see separate instructions for
InfoWINplus Master operation)
InfoWINplus basic
settings
(see section 4.6)
Language selec-
tion
Boiler SMSMB
1 only displayed when an MESplus control is present and this has been adjusted by a trained service technician in the basic settings.
4.5 Service level
System parameters, start-up or actuator test can be displayed, modified and/or performed on the Service level.
Structure on the Service level:
Information!
Only trained service personnel may perform system modifications on the Service level.