36
2. Operation
1
Only displayed if a feed system is present and if this has been adjusted by a trained service technician in the service level.
2.8.1.5 Setting probe switching
1
It is possible to set here which probe(s) (zones) are used for sucking pellets from the pellet storage room. The
setting options depend on the setting in the service levels in the „Type of pellet feed system“ menu item.
Information!
Changes on the service level may be performed only by trained service personnel (directions for
setting, see the FireWIN installation instructions).
Setting in the service levels
in the „Type of pellet feed
system“ menu item.
Setting options for
probe switching
Description
No feed – –
Suction turbine with 2 probes all probes
only probe 1
only probe 2
Removal from both probes, automated switching
Removal from probe 1 only, no switching
Removal from probe 2 only, no switching
Suction turbine with 3 probes all probes
only probe 1
only probe 2
only probe 3
Removal from all 3 probes, automated switching
Removal from probe 1 only, no switching
Removal from probe 2 only, no switching
Removal from probe 3 only, no switching
Suction turbine with 4 probes all probes
only zone 1
only zone 2
only probe 1
only probe 2
only probe 3
only probe 4
Removal from zone 1 and zone 2, automated switching
Removal from probe 1 and probe 2, automated switching
Removal from probe 3 and probe 4, automated switching
Removal from probe 1 only, no switching
Removal from probe 2 only, no switching
Removal from probe 3 only, no switching
Removal from probe 4 only, no switching
Suction turbine with 6 probes all probes
only zone 1
only zone 2
only probe 1
only probe 2
only probe 3
only probe 4
only probe 5
only probe 6
Removal from zone 1 and zone 2, automated switching
Removal from probe 1 to probe 3, automated switching
Removal from probe 4 to probe 6, automated switching
Removal from probe 1 only, no switching
Removal from probe 2 only, no switching
Removal from probe 3 only, no switching
Removal from probe 4 only, no switching
Removal from probe 5 only, no switching
Removal from probe 6 only, no switching
Suction turbine with 8 probes all probes
only zone 1
only zone 2
only probe 1
only probe 2
only probe 3
only probe 4
only probe 5
only probe 6
only probe 7
only probe 8
Removal from zone 1 and zone 2, automated switching
Removal from probe 1 to probe 4, automated switching
Removal from probe 5 to probe 8, automated switching
Removal from probe 1 only, no switching
Removal from probe 2 only, no switching
Removal from probe 3 only, no switching
Removal from probe 4 only, no switching
Removal from probe 5 only, no switching
Removal from probe 6 only, no switching
Removal from probe 7 only, no switching
Removal from probe 8 only, no switching
Suction turbine with mixer – –
To Next Page
Loading...
