EasyManuals Logo

WinGD W-X82 User Manual

WinGD W-X82
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
Operation
07501/A1
Winterthur Gas & Diesel Ltd.
17/ 18
Pertamina Medripal 570
Petrobras Marbrax
CID54APN
Marbrax
CID55
(BN 50)
Marbrax
CID57
PetroChina KunLun DCA
5070H
Premier Six OptMax BoB 300 additives for onboard blended cylinder oils (BN 40 to BN 120)
3)
OptMax
Shieldguard
5040
OptMax
Shieldguard
5070
OptMax
Shieldguard
50110 (BN 110)
OptMax Flex-
guard 140
(BN 140)
1)
Shell Alexia S3
(BN 25)
Alexia S4
(BN 60,
SAE 40)
Alexia 50;
Alexia S5
(BN 80)
Alexia S6 Alexia 140
(BN 140)
1)
SINOPEC Cylinder Oil
5025 (BN 25)
Cylinder Oil
5040
1)
Cylinder Oil
5070;
Cylinder Oil
5070S;
Cylinder Oil
5080S (BN 80)
Cylinder Oil
50100
1)
SK Supermar
CYL 25
(BN 25)
Supermar
CYL 40;
Supermar
CYL 40L
Supermar
CYL 70 plus
Supermar
CYL 100
Total Talusia LS 25
(BN 25)
Talusia LS 40 Talusia Univer-
sal (BN 57)
Talusia HR 70 Talusia Univer-
sal 100;
Talusia Optima
4)
United Oil
Company
Pte Ltd.
U Star Lube
Star Marine
570
Notes to Table 6:
1) This product is under testing and is not validated at this time.
2) Multiple formulations of this product are available. Not all of them are validated.
Speak to the supplier for more data about the products.
3) Multiple blending combinations with different system oils are possible. Not all of
them are validated. Speak to the supplier for more data about the blending
combinations.
4) Use in combination with <0.1% sulphur ECA fuel for up to 300 h validated by field
test.
Note: Intermediate cylinder lubricating oils (BN is between 50 mg KOH/g and
60 mg KOH/g) can be used with fuels in the sulphur range between 0.5%
m/m and 2.5% m/m, but their performance must be regularly monitored
with a piston underside drain oil analysis. The lubricating oil feed rate
must be adjusted to prevent a piston underside BN which is too low and
can cause excessive corrosive wear and scuffing. See the data given in
paragraph 3.4.
Note: If HFO with a sulphur content of between 1.5% m/m to 3.5% m/m is used,
see the data given in paragraph 3.2.
201708
Lubricating Oils

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WinGD W-X82 and is the answer not in the manual?

WinGD W-X82 Specifications

General IconGeneral
BrandWinGD
ModelW-X82
CategoryEngine
LanguageEnglish

Related product manuals