Operation
0210−1/A1
Winterthur Gas & Diesel Ltd.
3/ 5
6. Tools
Put hand-tools in locations where you can easily get access to them. Put special tools
and devices in positions in the engine room near the area where you use them.
All tools must be prevented from unwanted movement and must have protection from
corrosion.
7. Spare Parts
Keep large spare parts as near as possible to the position where they will be installed
and near the engine room crane.
You must prevent the unwanted movement of large spare parts.
All the spare parts must have corrosion protection. The corrosion protection agent
must be easy to remove. Examine the the corrosion protection agent at regular
intervals and replace if necessary.
The spare parts must also have protection from mechanical damage.
Spare parts that are removed from the store must be replaced as soon as possible.
8. Crankcase Doors − Open
WARNING
Danger: If you think that parts of the running gear or bearings
have become too hot, it is possible that the engine must be shut
down. Before you open the crankcase doors, you must wait for a
minimum of 20 minutes. This will prevent an explosion.
WARNING
Injury Hazard. Be careful when you touch hot parts with your
hands. This can cause injury.
2015-07
Safety Precautions and Warnings (General Information)
To Next Page
Loading...
