Operation
0210−1/A1
Winterthur Gas & Diesel Ltd.
1/ 5
Safety Precautions and Warnings (General Data)
1. General 1..........................................................
2. Warnings 1.........................................................
3. Lighting 2..........................................................
4. Clean Areas 2......................................................
5. Fire 2..............................................................
6. Tools 3.............................................................
7. Spare Parts 3.......................................................
8. Crankcase Doors − Open 3..........................................
9. Temperature 4......................................................
10. Crankcase, Cylinder, Exhaust Pipes and Scavenge air Receiver 4......
11. Carbon Dioxide (CO2) Gas 4.........................................
12. Crankcase Doors − Close 4..........................................
13. Turning Gear 5.....................................................
14. Instruments 5......................................................
15. Frost Hazard 5.....................................................
1. General
A correctly maintained engine gives problem-free and safe operation. Use the data
given below as a guide to the maintenance personnel.
For more data about the general maintenance procedures, see the Maintenance
Manual 0011−1 and 0012−1.
2. Warnings
WARNING
Injury Hazard. When you remove valves from the cylinder cover,
do not let oil or fuel fall on to the hot piston. This can cause an
explosion.
WARNING
Injury Hazard: If an oil mist detector activates an alarm, keep
away from engine. There is a risk of explosion. Do not go into the
areas adjacent to the explosion relief valves (see 0460−1
Instructions about the Prevention of Crankcase Explosions).
WARNING
Injury Hazard. Be careful when you disassemble the engine
without the correct tools and/or the necessary precautions.
Compressed springs can suddenly expand and cause injury.
WARNING
Injury Hazard. When you open valves and shut-off devices, hot
fluids or gases can be released. To prevent injury, always open
slowly the valves and shut-off devices and look at the direction
the medium is released.
Make sure that you read the maintenance instructions for the related parts.
2015-07
Operation
To Next Page
Loading...
Need help?
General
