Operation0210−1/A1
Winterthur Gas & Diesel Ltd.
2/ 5
3. Lighting
There must be good permanent lighting. Also, hand lamps must be available at
different locations in the engine room.
4. Clean Areas
CAUTION
Damage Hazard. Do not use water or cleaning fluids to clean the
UNIC electronic control boxes on the rail unit. Damage can occur
if fluids go into these control boxes.
Always keep the engine as clean as possible.
Keep the UNIC electronic control boxes on the rail unit clean and dry.
You must repair all leaks as soon as possible.
Dust, sand and chemical vapors must not go into the engine room.
5. Fire
CAUTION
Injury Hazard. Be careful when you use paints and solvents in the
engine room. These materials are flammable.
CAUTION
Injury Hazard. Insulation material that is soaked with oil or fuel is
flammable and must be replaced.
Make sure that you know the fire fighting instructions.
Before you do welding work or work that causes sparks, make sure that there are no
explosive fluids in the work area.
Make sure that fire fighting equipment is immediately available if you must do work
that causes sparks in the engine room.
Some components e.g. the turbocharger silencer and UNIC electronic control boxes,
must be protected with an applicable cover.
Keep covers and casings closed until the engine has cooled to decrease the risk of
fire or explosions.
The engine room and the area below the floor plates must be kept clean. This will
help prevent a fire in the engine room and in different areas.
Make sure that no fire extinguisher gases can be automatically released when
personnel are in the engine room.
Make sure that the emergency exits are clearly marked.
2015-07
Safety Precautions and Warnings (General Information)
To Next Page
Loading...
