Operation
0850−1/A1
Winterthur Gas & Diesel Ltd.
1/ 39
Failures and Defects of WECS Components
1. General 1..........................................................
2. Failure ID and LED Indications on FCM-20 2..........................
3. LED Indication on ALM-20 3.........................................
4. Failure Indications 4................................................
4.1 Failure Groups 4..............................................
4.2 Failure of Pulse Lubrication 4..................................
4.3 LED On / Off Codes 5.........................................
4.4 Failure ID 7...................................................
4.5 WECS Passive Failure 9.......................................
4.6 WECS Common Failure 18......................................
4.7 WECS Cylinder Failure 30......................................
4.8 WECS Pressure Failure 34......................................
4.9 WECS Critical Failure (WECS Engine Failure) 36.................
4.10 Malfunction of Cylinder Lubrication 37..........................
1. General
Failures and defects of WECS components cause failure messages which are
transmitted to the operator flexView and alarm and monitoring system (AMS).
The tables that follow will help you understand all failure indications. A two-digit LED
display for failure ID is given on the FCM−20 or ALM−20. An LED code is given on the
ALM−20 that can show some accurate failure indications.
Note: The two-digit LED display 2 shows the failure ID code (see Fig. 1).
2014
Operation Problems
To Next Page
Loading...
Need help?
General
