EasyManua.ls Logo

WinGD W-X82 - Page 363

WinGD W-X82
548 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
46051/A1
Winterthur Gas & Diesel Ltd.
1/ 3
Control Air Supply
1. General
The compressed air necessary for the air spring air (exhaust valves) and the turning
gear interlock comes from the control air board supply. The air must be clean and dry
to prevent blockages in the control units.
If the control air board supply system becomes defective, a decreased quantity of
compressed air will come from the starting air system.
The shut-off valves, pressure reducing valve, filters etc. that are necessary to supply
air to the different units are shown in the control air supply unit A (see Fig. 2 and
Fig. 3).
The numeric titles used to identify the parts of the equipment in the illustrations are
the same as those in the Control Diagram 40032.
016.826/08
1
2
3
4
5
6
7
DRIVING END
Fig. 1: Location of Control Air Supply
1 Control air supply unit 5 Condensate water container
2 Shut-off and venting cock 36HB 6 Condensate water drain valve
3 Shut-off and venting cock 36HC 7 Air bottle 287HA
4 Shut-off and venting cock 36HA
2014

Table of Contents

Related product manuals