3/4 16/10/2017
Summary for Operation Manual (OM)
4003-3/A1 2015-01 EAAD085118
Systems
Document updated with latest data:
-Page 11: PT2041A, PI2041L, 8.11-1 have been removed.
Address 313 has been changed to 314;
-Page 12: PT2041A, PI2041L, 8.11-1, PT2042A, PI2042L,
8.11-2 and connection 319 have been removed. Address
313 has been changed to 314. Only one servo oil pipe;
-Page 13: All signals related to the turbocharger updated;
-Page 14: All signals related to the turbocharger updated;
-Page 15,16: New group with PT2041A, PI2041L, 8.11-1,
4.23 added;
-Page 17,18: New group with PT2041A, PI2041L, 8.11-1,
4.23 added. Connection 319 has been removed;
-Page 19,20: Check point 3.17 top of ICU has
been
r
emoved;
-Page 22: Oil mist detection MK6 has been replaced by
MK7.
Date of publication 2015-07-28
Short Description of the
Engine
WinGD
for Operation
Correction of References to Fig 1; Chapter 3.2 Leak Test
deleted
WinGD
for Operation
Correction of References to Fig 1; Chapter 3.2 Leak Test
deleted
WinGD
Pressure and
Temperature Ranges
Torisional vibration damper (damper inlet):
Min. pressure value changed from 1.0 bar to
2.8 bar; max. pressure 5.0 bar (value added);
Note added;
WinGD
Alarms and Safeguards
PT2711A: ALM value changed from 1.5 bar to 2.2 bar;
Medium name changed to 'Torsional vibration damper oil
(steel spring damper)';
Note 5 changed
Change-over from HFO
to MDO and back
Changed description and changed procedure x
WinGD
Cylinder Liners and
Piston Rings
Changed procedure for running-in x
WinGD
Diesel Engine Fuels Text changed for Fuel additives x
WinGD
Update according to Service Bulletin (Text changes,
Particle Count; new Tables 4 and 5, updated Figures 1 and
2, updated Tables 6 and 7)
Thrust Bearing Minor text changes, Section 1.1 deleted x
2722-1/A1 2017-08 EAAD086283 Injection Valve Updated section drawing x
3326-1/A1 2017-08 EAAD086618
Text changed; Fig. 1 updated with shorter Guide rails x
WinGD
Table 4: Text changed; Table 5: Note deleted; Para 4.7:
step 2 deleted; Para 4.11: step 2 changed, step 3 added;
Para 4.12.1: step 4 changed
WinGD
Valve
WinGD
and Cutting In
Procedures updated (2.1: step 10 and step 12 to 16; 2.2:
step 6 to 10)
Fuel Pump Actuator Update drawing x