Wintriss wpc 2000 User Manual

1128500 WPC 2000 User Manual
x Table of Contents
How To Use This Manual
This manual shows you how to install, set up, operate, and troubleshoot the WPC 2000
Wintriss Clutch/Brake Control.
Chapter 1 provides an overview of WPC 2000 features and components, describes the
locations and functions of the switches and LEDs on the front panel and display, and lists
WPC 2000 specifications.
Chapter 2 shows you how to install both enclosure and non-enclosure versions of WPC 2000,
including optional components, and perform installation verification tests.
Chapter 3 shows you how to initialize and set up WPC 2000 and perform final checkout tests.
Chapter 4 shows you how to run the press, using WPC 2000’s Inch, Single-stroke, and
Continuous stroke selections and Two-hand, One-hand, and Foot modes.
Chapter 5 shows you how to respond to and correct the fault codes that appear on the display
when WPC 2000 detects an error.
Appendix A provides OSHA regulations and ANSI standards pertaining to the use of
presence-sensing devices for point-of-operation guarding on mechanical power presses.
Appendix B provides the safety standards you must meet when building your own Operator
Station.
Appendix C shows you how to install, wire, and troubleshoot WPC 2000 Option 1 user inputs.
The Glossary explains some terms that may be unfamiliar to you.
Figures at the back of the manual provide wiring diagrams that you can use in conjunction
with the instructions in Chapter 2 to wire WPC 2000 and its components.

Wintriss wpc 2000 Specifications

General

Brand	Wintriss
Model	wpc 2000
Category	Controller
Language	English