Page 5 of 46
WITT-GASETECHNIK GmbH & Co KG
Gas Safety- & Control Equipment
In section “Start-up and operation” you will learn how to proceed to analysis of your analysis
gas. Further you will learn how you can take the gas analyser out of operation e.g. for service
tasks.
In section “Operation of the analyser module” the handling of the integrated sensor / evaluator
unit is addressed.
Information on servicing tasks that you can perform yourself is given in the “Servicing and
maintenance” section. Here you will also find a failure location and correction table which will
help trouble-shooting in the event that any problems may occur.
As an appendix to these operating instructions you will find the technical data on the WITT gas
analyser, the schemes given in the technical data, along with drawings and a list of symbols.
This provides a short overview on the function and the controls of the gas analyser. You will
also find the numbers for the symbols on the function scheme and on the components them-
selves. With the aid of the list of symbols and the function scheme, you can identify compo-
nents in the gas analyser.
2.3 Rights to this manual
This manual is the copyright of WITT-GASETECHNIK GmbH & Co KG.
Without the prior written agreement of WITT-GASETECHNIK GmbH & Co KG these operating in-
structions are not permitted to be duplicated in whole or in part or be used in a manner contrary to
the company’s due interests.
It is only permitted to pass these operating instructions on to third parties in conjunction with the
gas analyser.
2.4 What symbols are used?
The warning symbol indicated hazards for personnel or the equipment.
It is imperative that these instructions are observed and followed.
The word “Warning” is placed in front of information indicating risk of personal injury or poten-
tially fatal hazards.
The word „Caution“ is placed in front of information indication potential equipment damage.
Note!
The pointing had marks general notes that explain operating procedures.
The „dot“ marks actions to be performed.
The „square“ is used to identify a list.
This symbol indicates that you should turn the page.
Option This symbol indicates possible alarm options or equipment options of the analyser.
To Next Page
Loading...
Need help?
General
