TPM
+
About this manual
Revision: 07 4022-D018396 en-5
1 About this manual
These instructions contain information necessary for the safe operation of the TPM+ dynamic/
TPM+ high torque/ TPM+ power servo actuator, referred to as the servo actuator in the following.
If this manual is supplied with an amendment (e.g. for special applications), then the information in
the amendment is valid. Contradictory specifications in this manual thereby become obsolete.
In case of questions on the special applications, please contact WITTENSTEIN alpha GmbH.
The operator must ensure that these instructions are read through by all persons assigned to install,
operate, or maintain the servo actuator, and that they fully comprehend them.
Store these instructions within reach of the servo actuator.
These safety instructions should be shared with colleagues working in the vicinity of the device
to ensure individual safety.
The original instructions were prepared in German; all other language versions are translations of
these instructions.
1.1 Signal words
The following signal words are used to indicate possible hazards, prohibitions, and important
information:
1.2 Safety symbols
The following safety symbols are used to bring your attention to dangers, prohibitions, and
important information:
This signal word points out to an imminent danger that can cause
serious injuries and even death.
This signal word points out to a possible danger that can cause
serious injuries and even death.
This signal word points out to a possible danger that can cause slight
to serious injuries.
This signal word points out to a possible danger that can cause
material damage.
A note without signal word draws your attention to application tips or
especially important information when handling the servo actuator.
General danger Hot surface Suspended loads Danger of being pulled
in
To Next Page
Loading...
