1-S14
L3130 · L3430 · L3830 · L4630 · L5030, WSM
ENGINE
Draining Coolant
CAUTION
• Never remove the radiator cap until coolant temperature is
well below its boiling point. Then loosen cap slightly to the
stop to relieve any excess pressure before removing cap
completely.
1. Stop the engine and let cool down.
2. Loosen the drain plug (3) to drain the coolant.
3. Remove the radiator cap (1) to completely drain the coolant.
4. After all coolant is drained, retighten the drain plug (3).
(When refilling)
• Fill the coolant between the “FULL” and “LOW” marks of
recovery tank (2).
W10314120
ROPS (Center ROPS Type)
1. Remove the upper frame (1) from ROPS lower frame (2).
2. Disconect the light connectors.
3. Remove the shields (3).
4. Remove the lower frames (2).
(When reassembling)
NOTE
• Do not firmly tighten all screws until most components are
attached.
W1031307
Battery, Front Grill, Skirt and Bonnet
1. Open the bonnet and disconnect the battery negative cable.
2. Disconnect the head light connector and remove the front grill (4).
3. Remove the left and right side skirts (3).
4. Disconnect window washer hoses (2). (Cabin model only.)
5. Remove the bonnet (1).
• When disconnecting the battery cords, disconnect the
negative cord first, when connecting, positive cord first.
W1057856
Coolant capacity (with
recovery tank)
L3130
L3430
6.0 L
6.3 U.S.qts
5.3 Imp.qts
L3830 (ROPS)
L4630 (ROPS)
7.5 L
7.9 U.S.qts
6.6 Imp.qts
L3830 (CABIN)
L4630 (CABIN)
8.7 L
9.2 U.S.qts
7.7 Imp.qts
L5030
9.2 L
9.7 U.S.qts
8.1 Imp.qts
(1) Radiator Cap
(2) Recovery Tank
(3) Drain Plug
A : FULL
B : LOW
Tightening torque
Lower frame mounting
screw
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 ft-lbs
(1) Upper Frame
(2) Lower Frame
(3) Shield
(1) Bonnet
(2) Window Washer Hose
(3) Skirt
(4) Front Grill
To Next Page
