1-S16
L3130 · L3430 · L3830 · L4630 · L5030, WSM
ENGINE
Steering Joint, Heater Hoses and Electric Wiring
1. Remove the tank frame support (2).
2. Remove the universal joint bolt (10) and steering joint support (3),
and then remove the steering joint (2).
3. Disconnect the hand accelerator wire and foot accelerator wire
(7). (A feet accelerator is not equipped in HST model.)
4. Disconnect the wiring connectors for engine stop solenoid (8),
engine tachometer sensor (9) and glow plug.
5. Disconnect the heater hoses (4), and then reconnect their hoses
to make loop. (Cabin model only.)
• Put a mark to the each heater hose before disconnecting.
6. Disconnect the wiring connector for window washer tank (5) and
compressor 1P connector (6). (Cabin model only.)
7. Disconnect the brake pedal rod.
(When reassembling)
• When accelerator wire is installed, adjust the wiring length as hit
both the idling speed adjusting bolt and the maximum speed
adjusting bolt by lever within the stroke of the accelerator lever.
• Set the steering joint (1) by the joint support (3) so that the
steering wheel is turned lightly.
• Be sure to check and adjust the brake pedal free travel. (See
page G-18.)
W1014863
(1) Steering Joint
(2) Tank Frame Support
(3) Steering Joint Support
(4) Heater Hose
(5) Window Washer Tank
(6) 1P Connector
(7) Accelerator Wire
(8) Engine Stop Solenoid
(9) Engine Tachometer Sensor
(10) Universal Joint Bolt
[A] ROPS Model
[B] Cabin Model
To Next Page
