3-M12
L3130 · L3430 · L3830 · L4630 · L5030, WSM
TRANSMISSION
■ Electronic Instrument Panel (IntelliPanel)
The 8 bits CPU is built into this panel.
The electronic instrument panel has functions to
receive several data of GST control from the ECU, and
output them to the liquid crystal display and the monitor
lamps. Moreover, it transmits the model data and the
sensor data, etc. also to the ECU.
W1015755
■ GST Lever Sensor
This sensor has function to detect the GST lever
position, and it is equipped on the bottom of the GST
lever (2).
This sensor is a variable resistor of the rotation
displacement type, and all resistance is 2 kΩ, and
electrically effective angle is 140 degrees. Then, the
lever position from N to 12 speed is output within the
range from about 0.7 to 4.2 voltages.
W1015847
■ Shuttle Switch
This switch has function to detect the shuttle lever
position, and it is equipped on the bottom of the shuttle
lever rod (2).
This switch has three contact points, which is
Forward, Neutral and Reverse, and detects their
position. As for GST control, it judges the shuttle start
condition.
W1015891
■ Engine Tachometer Sensor
This sensor is to detect the engine rotating speed,
and it is equipped on the left side of the engine gear
case. This sensor perceives tooth of the fuel camshaft
gear and emits the pulse. This pulse is sent to the
electronic instrument panel, and converted at the engine
speed. The data of engine speed is always sent to the
ECU.
W1015946
(1) GST Lever Sensor (2) GST Lever
(1) Shuttle Switch (2) Shuttle Lever Rod
(1) Engine Tachometer Sensor
To Next Page
