G-17
L3130 · L3430 · L3830 · L4630 · L5030, WSM
G GENERAL
Changing Transmission Fluid
CAUTION
• Be sure to stop the engine checking and changing the
transmission fluid.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, screw in the drain plugs.
5. Fill new oil from filling port after removing the filling plug (2) up to
the upper line of the dipstick (3).
6. After running the engine for a few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-7, 8.)
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different blands oil together.
W1068655
Transmission fluid
capacity
L3130, L3430
42 L
11.1 U.S.gals
9.2 Imp.gals
L3830, L4630
43 L
11.4 U.S.gals
9.5 Imp.gals
L5030
45 L
11.9 U.S.gals
9.9 Imp.gals
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
(A) Oil level is acceptable within this
range.
To Next Page
Loading...
