Transmitting data (USB interfaces) Multi 9310
82 ba75937e03 12/2011
11.4 Options for data transmission to a PC
Via the USB-B interface you can transmit data to a PC. The following table
shows which data are transmitted to the interface in which way:
11.5 MultiLab Importer
With the aid of the MultiLab Importer software, you can record and evaluate
measuring data with a PC.
Data Control Operation / description
Current
measured val-
ues of all con-
nected
sensors
manual z With <F2>/[USB output].
z Simultaneously with every manual
storage process (see section 10.1
M
ANUAL DATA STORAGE, page 75).
automatic, at
intervals
z With <F2__>/[USB output].
Then you can set the transmission
interval.
z Simultaneously with every auto-
matic storage process (see section
10.2 A
UTOMATIC DATA STORAGE AT
INTERVALS, page 76).
Stored mea-
sured values
manual z Displayed dataset with <F2>[USB
output] after calling up from the data
storage.
z All datasets with the Output to
RS232/USB function.
(see section 10.3.1 E
DITING THE
MEASURED VALUE DATA STORAGE,
page 78).
Calibration
records
manual z Calibration record with <F2>/[USB
output] (see section 5.2.6 C
ALIBRA-
TION DATA, page 38; section 7.3.6
C
ALIBRATION DATA, page 54; section
8.3.4 C
ALIBRATION DATA, page 60).
automatic z At the end of a calibration proce-
dure.
The following rule applies: With the exception of the menus, shortly
pressing the <F2>/[USB output] key generally outputs the display
contents to the interface (displayed measured values, measuring
datasets, calibration records).
More detailed information can be found in the MultiLab Importer
operating manual.
To Next Page
Loading...
