Settings Multi 9310
70 ba75937e03 12/2011
9.5 Sensor-independent settings
9.5.1 System
To open the Storage & config menu, press the <ENTER__> key in the mea-
sured value display. After completing the settings, switch to the measured
value display with <M>.
Default settings are printed in bold.
Menu item Setting Description
System / General / Language Deutsch
English
(more)
Selects the menu language
System / General / Acoustic signal on
off
Switches on/off the beep on keystroke
System / General / Illumination Auto
on
off
Switches the display illumination on/off
System / General / Contrast 0 ... 50 ... 100 Changes the display contrast
System / General / Switchoff time 10 min ... 1h ... 24 h Adjusts the switch-off time
System / General / Temperature
unit
°C
°F
Temperature unit,
degrees Celsius or degrees Fahrenheit.
All temperature values are displayed
with the selected unit.
System / General / Stability con-
trol
on
off
Switches on or off the automatic stability
control during measurement (see sec-
tion 9.5.3 A
UTOMATIC STABILITY CON-
TROL, page 71 )
System / Interface / Baud rate 1200, 2400, 4800,
9600, 19200
Baud rate of the USB Device interface
System / Interface /
Output format
ASCII
CSV
Output format for data transmission
For details, see section 11 T
RANSMIT-
TING DATA (USB INTERFACES), page 81
System / Interface /
Decimal separator
Dot (xx.x)
Comma (xx,x)
Decimal separator
System / Interface /
Output header
Output of a header for Output format:
CSV
System / Printer Settings for the integrated printer of the
Multi 9310 P.
For details, see section 12 P
RINTER
(
ONLY MULTI 9310P), page 83
System /Clock function Date format
Datum
Time
Settings of time and date.
For details, see section 4.5.5 E
XAMPLE 2
ON NAVIGATION: SETTING THE DATE AND
TIME, page 26
To Next Page
Loading...
Need help?
General
