Settings Multi 9310
66 ba75937e03 12/2011
9.2 ORP measurement settings
9.2.1 Settings for ORP measurements
The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Default settings are printed in bold.
9.3 D.O. measurement settings
9.3.1 Settings for D.O. sensors
(menu for measurement and calibration settings)
Settings The settings are available in the menu for measurement and calibration set-
tings. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Default settings are printed in bold.
3. Confirm the setting with <ENTER>.
4. Quit the menu with <M>.
Menu item Possible setting Description
mV resolution 0.1
1
Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
9.6.1 R
ESETTING THE MEASURE-
MENT SETTINGS, page 72).
Menu item Possible
setting
Description
Calibration /Cali-
bration record
- Displays the calibration record of the
last calibration.
Calibration / Cali-
bration data stor-
age / Display
- Displays the last calibration records
(max. 10)
Calibration /
Calibration data
storage / Output
to RS232/USB
- Outputs the calibration data storage to
the interface
To Next Page
Loading...
Need help?
General
