C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 5-29
Rev. A Section 5 – Configuration and Programming
Sep 2001
• IF THE CHANNEL IS TO BE PROGRAMMED FOR THE INTERNAL TRANSCEIVER MODULE IN
THE RT-5000, THE ZONE AND CHANNEL MUST MATCH THE ZONE, CHANNEL, AND
FREQUENCY INFORMATION PROGRAMMED INTO THE ITM.
PROG: 2=NEXT 3=BACK
RX FREQ=000.000
• Use the cursor/value knobs or the keypad to input the channel’s receive frequency. Press the MODE button to
go to the next menu page.
PROG: 2=NEXT 3=BACK
RX TONE=...
• Use the cursor/value knobs to input the channel’s receive tone. Refer to the section on changing tones via the
EDIT PAGE for details on specifying DCS and CTCSS tones. Press the MODE button to go to the next menu
page.
PROG: 2=NEXT 3=BACK
TX FREQ=000.000
• Use the cursor/value knobs or the keypad to input the channel’s transmit frequency. Specifiying a transmit
frequency of 000.000 indicates the channel is a receive-only channel. Press the MODE button to go to the next
menu page.
PROG: 2=NEXT 3=BACK
TX TONE=...
• Use the cursor/value knobs to input the channel’s transmit tone. Refer to the section on changing tones via the
EDIT PAGE for details on specifying DCS and CTCSS tones. Press the MODE button to go to the next menu
page.
PROG: 2=NEXT 3=BACK
TX POWER= HI
• Use the cursor/value knobs to input the channel’s transmit power as HI or LO. Press the MODE button to go to
the next menu page.
To Next Page
Loading...
Need help?
General
