Wunder-Bar JoeTap NITCOM - Page 91

Page | 91
23. Install the Left Pressure Regulator and the Rear Enclosure:
a) Inspect the barrier hoses protruding from the rear wall. Discard the Blue Barrier Hose and replace the Barrier
Hose with a new/unused hose if it is scratched or otherwise damaged that may cause leaks. See Figure L23.
b) Align the two (2) Gray Sealing Grommet (JT-12722) installed in the top two holes of the Rear Enclosure with the
two Blue Barrier Hoses installed in the rear bulkhead as per WI-1514-001. See Figure L24.
c) Push the Rear Enclosure so the two hoses push through the Gray Sealing Grommets and inside the Rear Enclosure.
See Figure L25.
d) Align the Blue Barrier Hose on the LEFT with the John Guest Fitting attached to the Pressure Regulator on the LEFT
and push the Left Pressure Regulator firmly to install the Barrier Tube fully. See Figure L25.
Route hoses through Gray Sealing
Grommet on both sides.
Figure L24: Hoses Inserted in the Gray Sealing Grommet.
Inspect tubing for scratches
Figure L23: Inspect Tubing for scratches.
Form new
cable bundle
Figure L22: Wire Bundle formed.