Operation
Power Supply Operation
Release 3.0 89
Setting step advance by time:
This procedure is continued from step 13 in the “To program a sequence:” table. It
describes how to program the sequence to advance a particular step by waiting for a
certain time period.
The completion of this procedure will bring you back to step 15 of the “To program
a sequence:” table. Continue programming the current step.
14 Set the step advance method. To Next Step
15 To go to the next step in
the sequence. This will
return you to step 7 in
this table. Repeat steps 7 to 14 for
all remaining steps in the sequence.
Press to exit auto
sequence programming
and return to the default
screen.
Step 2
Step # Do This You Will See
Set Step Time
1
Enter the Step duration.
The format of the display
is hh:mm:ss.ss.
Use the decimal key to move to
the right.
T=##:##:##.##
2 To Next Step
Step # Do This You Will See
ENTER
EXIT
ENTER
ENTER
To Next Page
Loading...
