Operation
Power Supply Operation
90 Operating Manual for XDC Series Power Supply
Setting step advance by trigger:
This procedure continues from step 13 in the “To program a sequence:” table. It
explains how to program the sequence to advance a particular step by waiting for a
certain trigger event. See “Editing Trigger Source of a Sequence” on page 96 for
more information about trigger event.
The completion of this procedure will bring you back to step 15 of the “To program
a sequence:” table. Continue programming the current step.
Step # Do This You Will See
Set Step Time
1
or . Use the scroll
keys to select the Wait for Trig
option.
Wait for Trig
2 To Next Step
ENTER
Note The default value for a sequence’s repeat time and trigger source is repeat once and
trigger from key. See
“Editing Repeat Times of a Sequence” on page 95 and “Editing
Trigger Source of a Sequence” on page 96 for an explanation of how to edit these
values.
To Next Page
Loading...
