5. Load the custom-size paper in the tray.
6. To engage the fine-adjustment block, pinch the levers and slide the guides inward.
LOADING PAPER IN TRAYS 3 AND 4 OF THE TANDEM TRAY MODULE
The control panel displays a warning message when the paper in the tray is in short supply, or when a tray is empty.
To change the paper size in Trays 3 and 4, refer to Configuring Trays 3 and 4 of the Tandem Tray Module.
To load the paper in Trays 3 and 4 of the Tandem Tray Module:
1. Pull out the tray until it stops. Wait for the tray to lower and stop.
2. Fan the edges of the paper before you load it into the paper trays. The procedure separates any sheets of
paper that are stuck together and reduces the possibility of paper jams.
Note: To avoid paper jams and misfeeds, do not remove the packaging from the paper until you are ready
to use it.
Xerox
®
AltaLink
®
B8145/B8155/B8170 Series Multifunction Printer User Guide 211
Paper and Media
To Next Page
Loading...
