Xerox AltaLink B8145 Series - Page 343

SSYYMMPPTTOOMMSS SSOOLLUUTTIIOONNSS
the debris creates a spot on the image. Clean all glass
surfaces with a lint-free cloth.
The reverse side of the original document shows on the
copy or scan.
Enable Background Suppression.
The image is too light or too dark. Adjust the Lighten/Darken or Contrast settings.
If the problem persists, for online support information, go to www.xerox.com/office/ALB81XXsupport.
Performing the Copy Calibration Procedure
To optimize copy job quality, perform the Copy Calibration procedure.
1. At the printer control panel, press the HHoommee button.
2. Touch DDeevviiccee.
3. Touch TToooollss.
4. Touch TTrroouubblleesshhoooottiinngg >> CCaalliibbrraattiioonn >> CCooppyy CCaalliibbrraattiioonn >> NNeexxtt.
5. To run the Copy Calibration procedure, follow the onscreen instructions.
Xerox
®
AltaLink
®
B8145/B8155/B8170 Series Multifunction Printer User Guide 343
Troubleshooting