Xerox
®
DocuMate
®
3115
User’s Guide
150
5. Move or resize region 1 until the sample image area you want is within the scan region.
Resize the region by clicking on one edge of the region outline and dragging the mouse. Move the
region by clicking in the region then dragging the mouse. Please refer to Move, Resize, or Delete
Regions for detailed instructions.
6. Create additional scan regions as needed by clicking anywhere in the sample image, hold your
mouse button down, and then drag your mouse to create a scan region. Release the mouse button
when the area you want is within the rectangle.
If you want to create a region that overlaps another region, hold the
Ctrl (control) key on the
keyboard while you click and drag the mouse to create the region. You can release the
Ctrl key
after you start creating the overlapping region. You only need to hold down the Ctrl key if the
starting point of the overlapping region is over another region. If you do not hold down the Ctrl
key, when you click on the area that has already been set as a region you will move the existing
region.
7. Click
Close when you are done creating scan regions.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
