Xerox
®
DocuMate
®
3115
User’s Guide
76
Configure Before Scan
You can set up the scanner so that, when you press a button or click it on the Button Panel, a different
scanning interface opens before the scanning starts. You can then use the interface to change the
Resolution, Scan Mode, and other settings. When you scan, the scanned image will still be sent as the
file type and to the same Destination Application already selected in the OneTouch Properties window
for that button.
1. Open the OneTouch Properties window.
2. Select the scan configuration
Configure Before Scan.
3. Click
OK or Apply on the OneTouch Properties window.
To Scan Using Configure Before Scan
1. Click the button you set up to use Configure Before Scan.
2. The TWAIN Interface opens.
3. Choose your scan settings, such as the Picture Type of Color, Grayscale or Black & White,
Resolution in DPI, and Page Size.
4. Click the
Scan button on the TWAIN Interface.
5. The item is scanned. When finished, click the
Done button and the image will be sent to the
Destination Application specified in the OneTouch Properties window.
To Next Page
Need help?
General
Weight and Dimensions
