Xerox
®
DocuMate
®
3115
User’s Guide
152
Move, Resize, or Delete Regions
Moving regions – to move a region, place your mouse cursor over the region you want to move. The
region will highlight indicating that it is the active region under the mouse cursor. Click on the region
and drag the mouse to move the region.
Resizing regions – to resize a region, place your mouse cursor over the edge of the region outline. The
cursor will change to a dual directional arrow. Click on the line and drag the mouse to resize the region.
If you click on the top or bottom edge, you can only resize the region up or down. If you click on the left
or right edge, you can only resize the region left or right. Click on a corner edge and then drag the
mouse to resize the region in all directions.
Note that you can only resize the scan regions to be within the scanner’s minimum and maximum
supported paper sizes. Please refer to the scanner specification table, in the maintenance section of the
user guide, for the supported paper sizes for your scanner.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
