6.6 Error Messages (in Alphabetical Order) 117
Install Drum
Cartridge
A drum cartridge is not installed.
Install a drum cartridge appropriate for the printer.
Refer to
• " Replacing the Drum Cartridge" (P. 130)
• " Types of Consumables" (P. 125)
Install Toner
Cartridge [X]
(X: Y, M, C, or K)
The X toner cartridge is not installed.
Install the X toner cartridge appropriate for the printer.
Refer to
• "Replacing the Toner Cartridges" (P. 128)
• "Types of Consumables" (P. 125)
Invalid Job
Press SET
The job was not printed since the request is not valid.
This message may appear when the accessory configuration settings differ from the
actual configuration.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Correctly specify the print request and try printing again.
Limit Reached
Press SET
(DocuPrint C1110 only)
The number of pages permitted to print that is set on the [Print Auditron] on
CentreWare Internet Services has reached the maximum.
Cancel the job by pressing the <Eject/Set> button on the control panel.
For information about the Print Auditron, consult your system administrator.
Load Manual Feeder
XXXXXXXX
Load Manual Feeder
YYYYYYYY
The paper is not loaded in the manual feeder. Load paper of the size (XXXXXXXX)
and type (YYYYYYYY) indicated in the message in the manual feeder.
After reloading the paper, the [SET to print CANCEL to Abort] message appears. If
printing the job, press the <Eject/Set> button. If cancelling the job, press the <Cancel
Job> button.
Refer to
• " Loading Paper in the Manual Feeder" (P. 77)
Load Tray 1
XXXXXXXX
Load Tray 1
YYYYYYYY
The paper is not loaded in the tray 1, or the size of the paper loaded in the tray 1
does not match the paper size specified by the print driver.
Load the size of the paper indicated in the message (XXXXXXXX) in the tray 1.
If the type of the paper loaded in the tray 1 does not match the paper type specified
by the print driver, load the type of the paper indicated in the message (YYYYYYYY)
in the tray 1.
If the the size and type of the paper loaded in the tray 1 does not match the paper
size specified by the print driver, the [SET to print CANCEL to Abort] message
appears after reloading the paper. If printing the job, press the <Eject/Set> button. If
cancelling the job, press the <Cancel Job> button.
Refer to
• " Loading Paper in the Tray 1" (P. 78)
Login Error
Press SET
(DocuPrint C1110 only)
The Authentication feature is enabled but you are not authorized to print from the
printer. Or, when you requested the job, you did not correctly enter your user ID and
password on your print driver.
Enter the correct user ID and password and try printing again.
Consult your system administrator whether you have access to the printer.
Refer to
• "7.8 Authentication and Auditron Administration Features (DocuPrint C1110 only)"
(P. 154)
One Side Printed
Load Paper in
Manual Feeder with
Print-side Up
The job requested manual 2-sided printing.
Stack the prints and turn the stack over. One sheet at a time, insert the very top print
that was turned over with the blank side facing down, into the manual feeder.
After loading the paper, the [Press SET] message appears. Press the <Eject/Set>
button to start printing.
Refer to
• "3.4 Manual 2-sided Printing" (P. 51)
Message Symptom/Cause/Remedy
To Next Page
Loading...
Need help?
General