4.2 Loading Paper 79
Note
• Do not fill paper above the maximum fill-line. Doing so
can cause paper jams.
4. Push the tray all the way into the printer
and extend the output tray extension.
If the tray is extended, the extended portion
sticks out from the back of the printer.
Important
• When inserting the tray, be careful not to get your
fingers caught between the tray and the printer.
5. Set the size and type of the paper on the
control panel.
Note
• For information on how to change the size and type of
the paper on the control panel, refer to " Setting the
Paper Type and Size of the Tray 1 on the Control
Panel" (P. 79)
Setting the Paper Type and Size of the Tray 1 on the Control Panel
When loading paper in the tray 1, you must set the size and type of the paper on the control
panel.
The default paper type and size for the tray 1 are [Plain Paper] and [A4 Portrait],
respectively. If you loaded paper other than the default paper type and size into the tray,
manually change its paper type and size on the control panel.
Make sure to set the paper type correctly on the control panel. If the paper type setting does
not match the actual type of the paper, toner may not fuse properly onto the paper, resulting
in smearing and poor print quality.
The following describes how to set the paper type and size on the control panel.
Note
• You can also display the message to set the paper size and type on the control panel every time you
load paper into the tray 1. Refer to " Display Screen" (P. 99) for details.
To Next Page
Loading...
Need help?
General