78 4 Paper
Loading Paper in the Tray 1
Important
• Do not remove or add paper to the paper tray during printing. Doing so can cause paper jams.
• Make sure to load paper when the power is switched on.
Note
• When loading
envelopes into the tray 1, make sure to load them correctly. For details, refer to " Loading
Envelopes" (P. 43).
1. Remove the tray 1 from the printer.
2. Adjust the paper guides to the size of the
paper.
To load A4 or smaller size paper
Pinch the length guide clip and slide it to
the size of the paper.
Pinch the width guide clip and slide it to
the size of the paper.
To load Legal 13" or Legal 14" size paper
Pinch the length guide clip and slide it to
the edge of the tray. Then, hold the right
rear side of the tray and extend the tray
to the size of the paper.
Pinch the width guide clip and slide it to
the size of the paper.
3. Load the paper into the tray 1 with the print
side facing up.
Adjust the paper guides until they rest
lightly against the edges of the stack of
paper.
To Next Page
Loading...
