A.5 Installing Additional Memory 185
Installation Procedure
Additional memory goes into the controller board right underneath a network expansion
card (optional). If your printer is the DocuPrint 1110 with a network expansion card installed,
remove the network expansion card to get an access to the RAM slot. For information on
how to uninstall/re-install the network expansion card, refer to the installation guide
provided for the network expansion card.
The following describes how to install additional memory to the printer.
The printer has one slot for installing a memory card. If you want to add memory when the
slot already has a memory card, replace the memory card with the one with larger capacity.
Important
• Before plugging or unplugging the interface cable connector, be sure to switch off the printer or unplug
the power cord from the power outlet. Plugging or unplugging the connector when the printer is on can
cause printer failure.
1. Switch the power off by pressing the power
switch on the left side of the printer to the
<O> position.
Unplug the power cord from the power
outlet and the printer.
2. Loosen the screw on the rear cover of the
printer, and open the cover.
To Next Page
Loading...
