186 A Appendix
3. Remove the rear cover from the printer by
pulling out the bottom tab of the cover from
the slot, tilting the cover, and pulling out the
top tab of the cover from the slot.
4. If a network expansion card is installed,
remove it temporarily.
5. If another memory card is already installed,
push the retaining clips on both ends in the
outward direction. After the memory card
pops up, pull it out at an angle.
6. Hold the new memory card so that the
notch on the card comes below the center
of the card.
7. Align the notch on the new memory card
with the projection on the RAM slot, and
insert the memory card at an angle into the
slot.
Important
• Make sure to insert the memory card securely until the
terminal area cannot be seen.
8. Check the following points to ensure that
the memory card is inserted correctly.
•The terminal area of the memory card
cannot be seen.
•The memory card is not inserted at an
angle.
To Next Page
Loading...
