4.2 Loading Paper 77
4.2 Loading Paper
This section explains how to load paper in the manual feeder or tray 1.
Loading Paper in the Manual Feeder
Important
• Make sure to load paper when the power is switched on.
Note
• When loading an envelope into the manual feeder, make sure to load it correctly. For details, refer to "
Loading Envelopes" (P. 43).
1. Adjust the paper guides to the width of the
paper.
Important
• Make sure that the guides are positioned just lightly
against the paper. The guides that are too tight or too
loose can cause paper jams.
2. Hold both sides of the paper with the print
side facing down close to the manual
feeder, and push it into the printer until it
automatically feeds.
Important
• Insert the paper straight into the manual feeder slot
correctly. If the paper is not fed properly, images may
be skewed or a paper jam may occur.
• Insert only one sheet of paper at a time into the
manual feeder. Otherwise, a paper jam may occur.
Note
• If you request a print job with [Paper/Output] > [Paper Source] set to [Auto] on your print driver, the
manual feeder cannot be auto-selected by the printer. Select [Manual Feeder] from [Paper Source] on
the print driver.
• When printing from the manual feeder, set the size and type of the paper on your print driver. For more
information, refer to the online help provided for the print driver.
To Next Page
Loading...
Need help?
General