Xerox DocuPrint C1110 - Page 97

5.2 Description of Menu Items 97
PCL
Specifies the settings for the PCL.
Item Description
Output Size Sets the size of the paper to be used when printing.
• [A4] (default), [A5], [B5], [8.5 x 11"], [8.5 x 13"], [8.5 x 14"], [7.25 x 10.5"], [Env 3.9 x
7.5"], [Env 110 x 220mm], [Env 162 x 229mm], [Env 4.1 x 9.5"], [Custom Size]
Orientation Sets the print orientation to [Portrait] or [Landscape].
• [Portrait] (default)
• [Landscape]
Font Sets the font to be used when printing. (default: [Courier])
Symbol Set Sets the font for symbols. (default: [ROMAN-8])
Font Size Sets the font size. You can specify the value in increments of 0.25 pt.
• [4.00] to [50.00] (default: [12.00])
Font Pitch Sets the font pitch (number of characters per inch).You can specify the value in
increments of 0.01 cpi.
• [6.00] to [24.00] (default: [10.00])
Form Lines Sets the form line (the number of lines per form). You can specify the value in
increments of 1.
• [5] to [128] (default: [64])
Quantity Sets the number of copies to be printed. You can specify the value in increments of 1.
• [1] to [999] (default: [1])
Image Enhance Sets whether to perform image enhancement.
Image enhancement is a feature that makes the boundary line between black and white
smoother to decrease jags and enhance the visual appearance.
• [On] (default)
•[Off]
HexDump Sets whether to print the data sent from a computer in ASCII codes corresponding to
the hexadecimal notation format in order to check the data contents.
• [Disable] (default)
• [Enable]
Draft Mode Sets whether to print in draft mode. This mode increases print speed but decreases
print quality.
• [Disable] (default)
• [Enable]
Line Termination Sets the line termination control codes. Set how you want the printer to interpret CR, LF
and FF control codes.
• [Off] (default)
The line termination command is not added.
CR=CR, LF=LF, FF=FF
• [Add-LF]
The LF command is added.
CR=CR+LF, LF=LF, FF=FF
• [Add-CR]
The CR command is added.
CR=CR, LF=CR+LF, FF=CR+FF
• [CR-XX]
The CR and LF commands are added.
CR=CR+LF, LF=CR+LF, FF=CR+FF
Output Color Sets the color mode. This settings is used when the color printing mode setting is not
specified for the print job that is sent to the printer.
• [Black] (default)
Prints in the black and white mode.
•[Color]
Prints in the color mode.