12 Safety Notes
The machine has ventilation holes on the
side, rear, and top panels. Ensure that the
machine is installed with the minimum wall
clearances of 130 mm from the rear vent
and 100 mm from the side vent. A poorly
ventilated machine can cause excessive
internal heat and fire. The accompanying
diagram shows the minimum clearances
required for normal operation,
consumables replacement, and
maintenance to ensure your machine
operates at peak performance.
When moving the machine, be sure to
unplug the power cord from the outlet
unless specifically instructed in the related
manuals. If the machine is moved with the
power cord connected, it can cause
damage to the cord which could result in
fire or electric shocks.
When moving the machine, do not tilt it
more than 10 degrees. If tilted excessively,
the machine may fall over and cause
injuries.
When the optional cabinet or castor base is
installed, be sure to lock the castor
stoppers. An unlocked machine may fall
over or slide and cause injuries.
For Power & Earth Connection
The power specifications are listed below.
The specifications that apply to your
machine depend on your machine
configuration. Connect the power plug only
to a properly rated power outlet. Otherwise,
it can cause fire or electric shocks. If in
doubt, contact our Customer Support
Center or dealers.
• Rated voltage 110-120 V
Rated frequency 50/60 Hz
• Rated voltage 220-240 V
Rated frequency 50/60 Hz
Ensure that the plug connection is free of
dust. In a damp environment, a
contaminated connector can draw a non-
negligible amount of current that can
generate heat and eventually cause fire
over an extended period of time.
Always use the power cord provided with
your machine. When an extension power
cord is required, always use a properly
rated cord.
• In Japan: 125 V/15 A
• In other countries: Contact our Customer
Support Center or dealers.
If you use a cord with an unspecified
current rating, the machine or plug may
emit smoke or become hot to the touch
externally.
Unit:mm
Unit:mm
To Next Page
Loading...
