14 Safety Notes
3. If the interrupter functions properly,
press the RESET button to exit the
test mode.
If the circuit does not operate, an electric
shock can occur on a poorly earthed
component. If you notice any unusual
condition, contact our Customer Support
Center your dealers.
When the machine is not used over an
extended period of time, switch it off and
unplug it. If an unused machine is left
connected to a power source for a long
period, degraded insulation can cause
electric shocks, current leakages, or fire.
Switch off the machine before connecting
the interface cable or optional accessories.
Connecting the cable or optional
accessories with a live machine can cause
electric shocks.
For Machine Operation
Do not place any liquid container such as a
vase or coffee cup on the machine. Spilt
water can cause a fire or shock hazard.
Do not place any metal parts such as
staples or clips on the machine. If metal
and flammable parts get into the machine,
they can short-circuit internal components,
and cause fire or electric shocks.
If debris (metal or liquid) gets into the
machine, switch off and unplug the
machine. Contact our Customer Support
Center or dealers. Operating a debris-
contaminated machine can cause fire or
electric shocks.
Never open or remove machine covers that
are secured with screws unless specifically
instructed in the related manuals. A high
voltage component can cause electric
shocks.
Do not try to alter the machine
configuration, or modify any parts. An
unauthorized modification can cause
smoke or fire.
This equipment is certified as a Class 1
laser product under [IEC60825-1]. This
means that the machine does not emit
hazardous laser radiation. Since radiation
emitted inside the machine is completely
confined within the protective housings and
external covers, the laser beam cannot
escape from the machine during any phase
of user operation. Do not perform any
operation apart from the instructions given
in the manual. There may be a danger of
laser beam leakage.
Do not use a highly flammable spray or
solvent near the machine. It can cause fire.
Never touch a labelled area found on or
near the fuser unit. You can get burnt. If a
sheet of paper is wrapped around the heat
roller, do not try to remove it by yourself to
avoid injuries or burns. Switch off the
machine immediately, and contact our
Customer Support Center or dealers.
When removing jammed paper, make sure
that no pieces of torn paper are left in the
machine. A piece of paper remaining in the
machine can cause fire. If a sheet of paper
is wrapped around the heat roller, or when
clearing a jammed paper that is difficult or
impossible to see, do not try to remove it by
yourself. Doing so can cause injuries or
burns. Switch off the machine immediately,
and contact our Customer Support Center
or dealers.
RESET button
TEST button
To Next Page
Loading...
