Moving and Repacking the System
Phaser® 8510/8560MFP Multifunction Product
8-31
3. Turn the scanhead transportation lock clockwise to lock the scanhead.
Caution: Scanhead damage can occur if the lock is not fully tightened.
4. Wait for the system to complete the cool-down period for the ink to solidify. The fan shuts
down when it is cool enough to move the system.
Caution: If you turn off the system but do not select
Shutdown for Moving System on
the control panel, the fan does not run, so you must wait longer for the ink to solidify. Wait
at least 30 minutes for the system to cool completely before moving or packing it.
5. Unplug the system after the cool-down cycle is complete.
8560-131
To Next Page
Loading...
