9. Select the down arrow on the Maintenance window to scroll down to Alignment
Adjustment.
10. Select Alignment Adjustment.
11. Select Auto Alignment Adjustment.
12. Select Print Calibration Chart.
13. Select Paper Supply.
14. Select the Paper Supply tray for the adjustment/profile needed.
15. Select the Save button.
16. Set the area coverage if needed Coverage is the amount of toner covering the page.
Coverage 1 is for Side 1 and Coverage 2 is for Side 2 of the page. You can usually
leave the coverage set to 1. However, if you are experiencing alignment problems
repeadedly on print jobs with high area coverage, you can increase this value
incrementally up to 10.
17. Set the number of sheets to print.
With multiple sheets, the software will use the average values from all sheets to make
adjustments. Therefore it is best to set at least 5 sheets. and so the variation between
the sheets will be reduced.
18. Select Print.
19. After the prints are output, touch Confirm.
20. Collect the printed targets from the output area of the press.
Continue to Scanning the Targets.
Related Topics:
Scanning the Targets
5-3Xerox
®
Versant
®
80 Press
System Administration Guide
Simple Image Quality Adjustment (SIQA)
To Next Page
Loading...
