Power Saver Settings
From the CentreWare Internet Services main screen, select the Properties tab. In the
Properties panel shown at the left of the screen, select General Setup and Power Saver
Settings.
The Power Saver mode settings you define here, as well as whether to deactivate the
Power Saver feature, can also be made at the press touch screen.
• Time to Low Power Mode
In Low Power mode, the power to the touch screen and press is lowered to save power.
Specify in this field the amount of time between the last operation on the press and
when to enter Low Power mode. The default is 1 minutes. Type from 1 through 240
minutes.
• Time to Sleep Mode
In Time to Sleep Mode, the power is lowered even more than Low Power mode. Specify
in this field the amount of time between the last operation and when to enter Sleep
Mode. The default is 1 minutes. Type from 1 through 240 minutes.
Note
The default settings for both modes ensure Energy Star compliance. If you change
these modes to a higher setting than the default, Energy Star certification may no
longer be valid.
• Power Saver Deactivation
You can partially or completely deactivate the use of the Power Saver feature.
If you select Deactivate Partially when Printing, the feature will not be initiated
after a job completes printing.
Select Apply to save settings.
Internet Services Settings
From the CentreWare Internet Services main screen, select the Properties tab. In the
Properties panel shown at the left of the screen, select General Setup and Internet
Services Settings.
Specify and enter the amount of time to pass before the job and status pages are
automatically refreshed. Select Apply to save settings.
Xerox
®
Versant
®
80 Press10-4
System Administration Guide
Configure CentreWare Internet Services Settings
To Next Page
Loading...
