Note
The ports and TCP/IP configuration also can be performed using Configure CentreWare
Internet Services Settings.
1. Login as the Administrator.
2. Press the Machine Status button on the press User Interface (UI).
3. Select the Tools tab on the UI.
4. Select System Settings.
5. Select Connectivity & Network Setup > Port Settings .
6. Select SOAP.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
7. Select SMNP.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
8. Select Internet Services (HTTP).
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
9. Select Close repeatedly until the main Tools screen displays.
10. If necessary, set the IP Address; choose one of the following:
• To set an IP address, refer to Connectivity & Network Setup.
• If an IP address is already set, skip this step.
• If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. If an IP address cannot be obtained automatically or
manual configuration is preferred, confirm the settings of an IP address, a subnet
mask, and a gateway address.
11. Select Close repeatedly until the main Tools screen is displayed.
12. Exit the System Administrator Mode.
13. Print a configuration report to confirm that all the ports are enabled and that TCP/IP
is set up correctly.
Configuring the SNMP Port through CentreWare Internet Services
1. Connect to CentreWare.
2. Configure the transport protocol for the SNMP port.
a) Click on the Properties tab.
b) Click on Connectivity.
c) Click on Port Settings.
Xerox
®
Versant
®
80 Press11-16
System Administration Guide
Configure Environment Settings for Scan Services
To Next Page
Loading...
