Xerox Versant 80 Press - Basic Maintenance Procedure; Initializing the Hard Disk

Finisher Adjustment (optional)
This feature is available only if the one of the following finishers is attached to the
press:
• Standard Finisher
• Booklet Maker Finisher
• Standard Finisher Plus
Use the Finisher Adjustment feature to select the settings for the following options:
• Adjust Fold Position
• Using DFA Finisher Profiles (for Third-Party Finishing Devices)
Basic Maintenance Procedure
1. Log in as the administrator.
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select System Settings > Common Service Settings .
5. Select Maintenance.
6. Select the Maintenance item to be set or changed.
7. Select Change Settings.
8. Select the desired setting for the option.
9. Select Save.
10. Select another item to set or change and repeat the previous steps as needed.
11. Select Close.
The main Tools screen displays.
12. Exit the administrator mode.
Initializing the Hard Disk
1. Log in as the administrator.
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select System Settings > Common Service Settings .
5. Select Maintenance.
6. To initialize the machine hard disk, select Initialize Hard Disk.
a) From the Initialize Hard Disk screen, select the partition to be reformatted.
b) Select Start.
c) Select Yes.
When reformatting completes successfully, a message screen appears.
d) Select Confirm.
e) Select Close to return to the Maintenance screen.
7. To delete the machine data, select Delete All Data.
a) From the Delete All Data screen, select Start.
4-15Xerox
®
Versant
®
80 Press
System Administration Guide
System Settings (Tools Administrator Mode)