NVM Read Write
The Xerox Service Representative uses this feature to change certain system settings.
Billing Impression Mode
Identifies the billing capability used on the press and how to track impressions made
on large size sheets such as A3 paper. There are two setting selections. The default
setting is A3 Impression Mode that counts all print impressions equally. Or the system
may be set to A4 Impression Mode that counts large impressions (depending on the
customer and market region). It allows normal impression meters to increment by two
when a large impression is made.
Supplies Activation Code
Supports converting the press from Meters to Sold billing.
Tray 5 Option
Tray 5 is not automatically detected by the system. When Tray 5 is installed, use this
feature to show (enable) or hide (disable) Tray 5 in the system configuration graphic
that is displayed on the press touch screen and on the Stock Library Manager.
Tray 5 Guide Adjustment
Calibrates the paper guides of Tray 5 to their minimum and maximum widths. Use this
routine when the tray size sensor is replaced to calibrate the paper size detection for
Tray 5. Refer to Setting the Tray 5 Guide Adjustment.
Technical Key Operator
Access this area to reset the HFSI counter for a newly-replaced CRU (customer
replaceable unit) such as the Suction Air Filter at the rear of the press. The HFSI counter
of the selected replaceable part will be reset to 0. This tracks when the consumable
needs to be replaced next. Refer to Resetting a HFSI Counter.
Density Uniformity Adjustment
Refer to the Simple Image Quality Adjustment (SIQA) chapter for detailed information
and procedures.
Alignment Adjustment
Choose either Auto Alignment Adjustment (SIQA chapter) or Manual Alignment
Adjustment.
Adjust Paper Curl
Use this feature to change the paper curl settings either at point of need or to create
individual paper curl profiles for specific paper types, weights, and trays. Refer to
Correcting the Paper Curl for detailed information and procedures.
Xerox
®
Versant
®
80 Press4-14
System Administration Guide
System Settings (Tools Administrator Mode)
To Next Page
Loading...
